Application

In order to fill and cover all pores and voids, Drizoro Maxseal should be applied using a fibre brush or a nylon fibre broom, such as Maxbrush or Maxbroom respectively.

Apply the product on the surface in a thick layer, making in a homogeneous and continuous coating. Do not spread the product as if it were paint.

Once Drizoro Maxseal® has been spread, it must not be brushed again. A second layer must be applied in the perpendicular direction of the first one, with a waiting-time of 12-16 hours between layers.

Second layer may be texture rolled or trowel finished to achieve decorative finishes.

Drizoro Maxseal can be applied using spray equipment.

In order to ensure complete and uniform coverage and proper sealing of all voids etc, the sprayed area should be brushed or broomed.

If Drizoro Maxseal  is going to be rendered over, on vertical surfaces, it is advisable to apply the second layer horizontally.

For pipelines, the second layer should be applied in the direction of the water flow.

Application conditions

The optimum temperature range for application is from 15 oC to 20 oC. Do not apply Drizoro Maxseal if rain is expected within 4-6 hours after the application.

In winter, do not apply Drizoro Maxseal below 5 oC or if such temperatures are expected within 24 hours after application. Do not apply the coating on frozen or frosted surfaces.

For applications during hot temperatures and windy conditions, i.e. summer time, the surface must be wet with plenty of water. Once Drizoro Maxseal Cementitious Waterproofing Membrane has been applied , if product appears to be drying out too quickly spray the surface slightly with a fine mist of water.

Curing

Allow Drizoro Maxseal to cure for at least 7 days at 20 C and 50% of relative humidity prior to immersion in water.

Lower temperatures and higher relative humidity increase the curing time.

Cleaning.

Before product hardens, all tools and equipment must be cleaned immediately with water. Clean cured material by mechanical means.