ConcreKleen – Concrete Cleaner & Degreaser


ConcreKleen Concrete Cleaner Degreaser

 A liquid applied cleaner to remove dirt, oil, and stains from concrete. Creates a chemical reaction to clean and whiten concrete

Available in 4 different container sizes


ConcreKleen Concrete Cleaner Degreaser

Advanced Concrete Cleaner And Degreaser Based On A Scientific Blend Of Ingredients Environmentally Friendly


Concrekleen Concrete Cleaner Degreaser is a specially formulated Industrial Strength Concentrated Fluid applied degreaser and cleaner for industrial, commercial and residential use. With no solvents or other aggressive chemicals, it allows effective cleaning without affecting the environment and with no changes to the colour, appearance and texture of the substrate.

The special non-flammable, non-carcinogenic, biodegradable formulation provides an “As New Look” and leaves no residue.
The product is Corrosive.

Application fields:

  • Cleaning of sidewalks, driveways new or old constructions affected by pollution.
  • Removes pollution stains and dirt from solid and fluid fuels, road traffic, and industrial fallout. etc., on concrete, brick, tiles or stone.
  • Ramps, oil stained concrete, barges, car parks, gas stations, shopping centres.

Advantages of Concrekleen Concrete Cleaner Degreaser:

  • It does not attack the surface treated.
  • Dissolves deposits from combustion processes, removing them.
  • Will clean off discolouration caused by leaves or rust stains.
  • No special protective equipment is required,
  • safe for users and the environment, and requires only safety goggles, gloves and rubber boots.
  • Cleaning of sidewalks, driveways, and any construction affected by pollution.
  • Replaces aggressive acid and basic cleaners.
  • Non- carcinogenic and non-flammable.
  • Environmentally friendly

Application Instructions:

Limitations: Apply in good weather when air and surface temperature are above 7°C. and surface temperature is at least 5°C. above the

Dew Point. For optimum application properties, materials should be between 21- 32°C. prior to application.
Maintain unused material in closed containers in protected storage at 5-32°C out of direct sunlight.

Surface Preparation:

  1. Water all surrounding grass and shrubs well before starting application of – Concrekleen Concrete Cleaner. Clean all oil and grease off the surface, using Bluee- PowerClean Degreaser. Remove excessive build-up, sweep off all loose material or unsound particles from the surface to be treated to optimize the consumption of – Concrekleen
  2. Apply –Concrekleen Concrete Cleaner with a plastic garden pump sprayer.
  3. Allow 3-5 minutes for –Concrekleen Concrete Cleaner to deep clean the pores of the concrete depending on the extent of the soiling and the durability of the surface (This is why Testing is important)
  4.  Agitate concrete surface using a stiff nylon brush, broom or rotating concrete scrubber and a 3000 psi pressure washer.
  5. Power wash away all dirt and remaining – Concrekleen and rinse well. Pressure wash off and re-apply –Concrekleen Concrete Cleaner to achieve the whitening.
  6. Scrub any stains with a stiff non bristle brush. Pressure wash with a minimum of 3000 psi We recommend OH&S Compliance chemical gloves, eye protection and rubber boots.
  7. Rinse everything with plenty of water. Rinse equipment immediately after use
  8. Apply –Sealtight Masonry Sealer to seal the surface and to keep future stains from penetrating.
  9.  Clean-up: Clean all equipment with – Bluee-Powerclean Degreaser and water or warm soapy water.

Health and Safety:

Safe storage and handling of acid use dictate that adequate health and safety precautions be observed with this product.

The user is specifically directed to consult at .au the current Material Safety Data Sheet for this product as well as precautions contained in product labelling, and also the Technical Data Brochure

Health Hazards (Acute And Chronic):

Breathing: Mist can cause damage to nasal and respiratory passages.

Eyes: Causes Burning
Skin: Causes Bums
Swallowing: Resulting in Severe Damage to Mucous Membranes.

This Product Is Corrosive.

Technical Data:

Signs And Symptoms Of Exposure:


Medical Conditions Generally Aggravated By Exposure: N/A Emergency And First Aid Procedures:

Eyes: Flush with clear water for 15 minutes. SKIN: Flush with a solution of water and baking soda.

Ingestion: Drink large volumes of clear water.

For Cases Of Ingestion Or Eye Exposure, Seek Medical Attention.

Additional information

Weight N/A